邢台保洁服务有限公司

清洁抽油烟机“防”比“治”重要 。就像健康问题永远是“防”比“治”重要一样，清洁油烟机的最好方法也是一个“防”字。买回来的新油烟机在启前用，先在两只储油盒里撒上薄薄一层肥皂粉，再注入约三分之一的水，这样，回收下来的油就飘在水面上，而不是死死凝结在盒壁上了，等废油将满，倒掉后再如法炮制。

Clean lampblack machine "prevention" than "governance" important. Just like the health problem is always "anti" than "governance" is important, the best way to clean hood is also a "anti" word. The new hood bought at Kai before, in the first two storage box with a thin layer of soap powder, and then injected into about 1/3 of the water, so that the recovered oil floating on the water, rather than tightly condenses on the walls of the box, such as oil will be full, and then modeled on it.

抽油烟机的机身又如何防油呢？在启用前，我们可以用微湿的抹布蘸上洗碗用的洗洁剂（不    要兑水—）擦拭机身，扇叶上也尽可能擦到，等自然干透后，防止油烟黏附的'洗洁剂涂层'就做好了。一段时间之后，如果机身摸上去手感发黏，那就是到了要清洁机身的时候了。由于油污与机身之间已作过“防护涂层”，因此，用80℃的热水直接清洗机身，油污就会先洗下来。清洁工作结束后，不要忘了再涂一遍洗洁剂在机身上，要涂得稍厚，湿度控制在'不滴挂'即可，然后再在开关键上覆盖保鲜膜。

Lampblack machine body how to prevent oil? Before the opening, we can use a damp cloth dipped in dishwashing detergent (not against water) to wipe the body, the blade as much as possible to clean, natural dry, prevent lampblack adhesion 'detergent coating' is ready. After a while, if the body feels sticky, it's time to clean the body. As the oil and the fuselage have been "protective coating", therefore, with 80 degrees of hot water directly clean the fuselage, oil will first wash down. After cleaning, don't forget to paint it again. The detergent is on the body. It should be painted a little bit thick. The humidity is controlled on the "no drip hanging", and then covered with plastic wrap on the opening key.